For areas that allow the tree to fall only on a certain area, they use this area.
After all, this method is based on the felling of trees in parts.
Industrial climbers (arborists) are specialists whose profession includes three specialties at once.
In the past few years, most of the densely populated cities have needed sanitary felling of trees.
Moreover, it will preserve the life and development of young plants that exist nearby.
But you will have to carefully examine each of them in spring or autumn.
State
A healthy tree is completely devoid of dry branches.
Accordingly, the crown is completely lush and green.
But the abundance of green leaves is by no means an indicator of the health of the plant.
Trees are living organisms.
This means that with age, they are more susceptible to diseases and deformities.
In other words, they are simply not able to withstand even moderate wind loads.
Particularly dangerous branches are considered completely dry or at least partially broken off dried branches.
Longitudinal and transverse cracks also translate trees into the category of emergency ones.
Deep transverse cracks, which cannot be strengthened, are especially terrible.
A small angle of branching is a clear sign that the branch is poorly fused with the trunk.
The small distance between them leads to the formation of a pocket from the bark.
And such a phenomenon speaks of questionable strength in this place.
Also, the ingrown bark often plays the role of a wedge.
Biologists argue that the small-angle rarely occurs on its own, from the genetics of the tree.
The first method is simpler, but it is not always possible to use it.
There must be a certain fall space; otherwise, it becomes dangerous to resort to.
Then it becomes necessary to contact professional climbers.
Their help is invaluable, as it guarantees the complete safety of property and safety.
How Is Dead Wood Cutting Done?
How is the work going?
Thus, it is possible to correct the direction of its fall.
The method is the simplest and cheapest, but it is not always possible to resort to it.
On one side, a wedge is made, and on the other, the tree is finished.
Then the rope is pulled and the tree can be safely removed.
If the whole tree cannot be uprooted, they resort to cutting down in parts.
Before that, the trees are pruned.
Sawing A Tree With Dropping Parts Down
It is necessary to provide space for dumping sawn branches.
The climber climbs to the top and removes branches that can serve as an obstacle to the fall.
A preliminary cut is then made to guide the fall.
After that, it remains to finish the barrel.
This is the most expensive and dangerous method of removing a tree for a specialist.
In this case, you could resort to the help of specialists.
The service providers will eliminate any risks to property and people when cutting deadwood.
Plus the diameter of its trunk is less than 20 cm.
In this case, you might safely cut it yourself.
For this you will need:
Once youve prepared everything you need, cut off the large branches first.
Then cut off the trunk (leave a meter and a half from the ground).
If it is more convenient, cut them with a hacksaw or chop them with a sharpened heavy shovel.
With these tools, it is easy to work with roots as thick as an arm.
Therefore, initially decide whether it is better to invite arborists to remove a large tree from the site?
Dig in deeper, chopping off smaller roots along the way.
Now invite a stalwart assistant who will tilt the tree, holding the trunk higher.
So you gotta act until the tree falls.
If it is difficult to tilt the size, tie a rope around the barrel.
Conclusion
Cutting down trees on your own site during construction requires special skills andcare.
After all, services for non-professional felling of trees in the city can cause damage to nearby buildings.
Therefore, if you gotta cut down a tree, you should seek help from qualified specialists.
The tree removal service providers offer professional arborists services based on proven modern technologies.
