Genie is another reputable brand when it comes to garage door openers.
If you have older models, you might want to know how to program your Genie garage door opener.
The good part is that these programming types can be done in just four steps each.
If you are curious as to how, read on.
Doing this only includes two steps:
1.
Locate the program or set button in the main control unit
Press the button for at least 3seconds.
There are two LED lights that you should be on the lookout for.
The small button should turn blue while the longer button must be in purple.
The LED lights in the garage door opener should blink and then turn off.
If it does this, the garage door opener can now be opened and closed using your remote control.
*Note: You have a 30-second window time to accomplish each step.
Once the garage door openers lights turn red, you must repeat the process.
Usually, a Genie keypad can only be programmed for a single garage door.
There are other steps required for opening multiple garage doors using a Genie keypad.
After that, press the program or set button until the small LED light blinks red.
Next, set your new pin
Key in the Genie code again and then press the program button.
slide in your new pin.
you might have an eight-digit code for your pin for additional security.
Press the program button again to set the new code.
The longer LED light must turn purple.
Here is how to program the Genie garage door wall console.
When it does, here are some troubleshooting tips to keep in mind.
How do I replace a 2032 lithium coin battery for my new Genie garage door opener?
Why is my Genie garage door opener closing and opening on its own?
You would know which one is on short circuit once you run them in turn.
If it is the remote, change the batteries or replace it.
Why wont my Genie garage door close completely?
Why is there an immediate reverse when the door is shut closed?
What causes an opener to run but the garage door would not move?
It is that red cord that hangs from the garage door like a pulley system.
When this is pulled, it automatically converts the open and close system into manual locking.
If this is the culprit, just snap back the cord in place.
Where is the Learn button on Genie garage door opener?
you’ve got the option to also check this video for a more accurate find.
The learn button is important in many troubleshooting and programming steps.
It is imperative that you know where it is found.
How do I program a universal remote for a Genie garage door opener?
What should I do if I pressed the universal remote excessively and it stopped responding?
To troubleshoot this, you should probably leave the remote in place for at least two minutes.
After this, remove the batteries and then put them back immediately.
Go back to step 1 and repeat the process.
How do I reset a Genie universal remote?
How many garage door openers can a Genie universal remote open?
They are easy to execute though, so it should not be a problem.
There are also troubleshooting tips that you should grow familiar with as they could happen more commonly than expected.
